STANDARD KEY FORD

TPMS Sensor Relearn

1. Set tire pressure

Inflate all tires to the pressure shown on the driver-door sticker.





2. Prepare the vehicle

Set the parking brake

Make sure the ignition is OFF

3. Start the relearn sequence

-Press and release the brake pedal

Turn the key OFF → RUN three times, ending in RUN

(Dash lights on, engine NOT running)

-Press and release the brake pedal

-Turn key to OFF

-Turn the key OFF → RUN three times again, ending in RUN

4. Confirm relearn mode

The horn will beep once

The TPMS light will flash once

If equipped, the dash will say “Train LF Tire”

This means relearn mode is active.

5. Train the tire sensors

Use a TPMS scan tool / Trigger Tool

Wait for the horn beep

Move to the next tire in this order:

Left Front (LF)

Right Front (RF)

Right Rear (RR)

Left Rear (LR)

6. Finish relearn

After the Left Rear tire:

Dash will show “Training Mode Complete” and TPMS Light will turn off

Turn ignition OFF and no horn sound confirms success

If the horn sounds when turning OFF, the relearn failed and must be repeated

7. Turn ignition OFF

Relearn is complete.